ICTP9511 IV curve tracer probe is usually used with an oscilloscope. Display the I-V curve trace of measured object on the screen of oscilloscope to measure or analysis the resistor, inductor, capacitor, transistor, transformer etc. component. It also can be used to analysis the various parameter of circuit.
If you want to verify or repair a PCBA or a wrong instrument, comparison to a golden board could be very smart approach in daily practice. When you can use it expertly, the efficiency will be much higher than multi-meter and routine probe.
Perhaps the most excellent is that the ICTP9511 could be used while the object PCBA or instrument could not be allowed to energize or power on. In fact, we often confront these conditions. For example, if a wrong instrument be powered on, the faults maybe augment and increase the loss.
It may be used at the following location usually:
- Check general component & components combination
- Check transformer or motor coils
- Check and repair PCBA
- Check and repair electronic instrument
- Measure and Analysis the circuit parameter
- Basic electronic experiment
Main Specifications
Electrical Specification |
AC adapter output |
AC9V, 100mA |
AC adapter input |
AC220V, 50~60Hz |
Typical mechanical specification |
Input cable length |
Approximately 100cm |
Output cable length |
Approximately 50cm |
Probe body |
120×55×24(mm) |
Weight |
300g |
Environment Specification |
Operating temperature |
0~40℃ |
Storing temperature |
-10~45℃ |
Operating humidity |
85%RH |
Storing humidity |
90%RH |
Operating altitude |
3000m |
Storing altitude |
12000m |
Example I-V curve trace for some components:
|